Table of contents
- 1. Prerequists R2DBE
- 2. Prerequisits DBBC3
- 3. System initialization
- 3.1.1. Module initialization
- 3.1.2. Configure the backends (R2DBE only)
- 3.1.3. Configure the DBBC3
- 3.1.4. Check signal routing
- 3.1.5. Check time synchronization
- 3.1.6.
- 4.
- 5.
- 6.
Prerequists R2DBE
- Go through the setup instructions and verify that the system is up and running.
- Make sure that the modules have been initialized, grouped and labeled.
Prerequisits DBBC3
- Go through the system setup procedure for the DBBC3 and verify that the system is in a working condition.
- Make sure that pv-mark6-3 and pv-mark6-4 are up and running
System initialization
Module initialization
ONLY IF REQUIRED: Initialise the modules using the following command. It has to be repeated separately for each Mark6 that has modules that need initialising (example below references the Mark6 using hostname 'recorder1'). This command will erase all existing data on the modules. If you are unsure whether to initialise a set of modules, request guidance from AOC.
backendctl mark6 recorder1 modules 1,2,3,4 init-fresh
if the modules are still in "open" state they must be unmounted before
backendctl mark6 recorder1 group unmount
Repeat for all recorders
Configure the backends (R2DBE only)
backendctl whole configure
Configure the DBBC3
make sure the DBBC3 client is not running
cd /home/oper/rottmann/dbbc3/utilities ./setupDBBC3_OCT_D.py dbbc3 -n 4
Check signal routing
backendctl chain all check routing
Check time synchronization
backendctl chain all check timesync
