Table of contents
System schematics
Important note:
The DBBC3 is showing syncrhonisation issues in this session (actually since Nov. 12). Investigations are ongoing, but it is yet unclear of the impact on data quality that the problem may have. The vdif headers and time look ok, but we also saw jumps in the 1PPS and the sampler offests that could create issues only detected at correlation.
Setup 86 GHz
Target band: 86.000 - 87.024
1st LO: 93.0 GHz
RF: LSB 5-9 GHz
2nd LO (DBBC3): 9.048 GHz
Sky freq: 83.952 - 88.048 GHz
| sky | 83952 | 85976 | 86000 | 87024 |
| after 1st DC | 9048 | 8024 | 7000 | 5976 |
| after 2nd DC | 0 | 1024 | 2048 | 3072 |
=> DBBC3 should use filter1= 2000-3000
Setup 230 GHz
Target band: 215.000 - 216.024
1st LO: 221.010 GHz
RF: LSB 5-9 GHz
2nd LO (DBBC3): 8.058 GHz
Sky freq: 211.962 - 216.058 GHz
| sky | 212952 | 213976 | 215000 | 216024 |
| after 1st DC | 8058 | 7034 | 6010 | 4986 |
| after 2nd DC | 0 | 1024 | 2048 | 3072 |
=> DBBC3 should use filter1 = 2000-3000
DBBC3 setup
- load normally the OCT_120 firmware
- run dbbc3ctl.py and do check system all
- run /home/oper/rottmann/dbbc3/utilities/setupFPT_Nov22.py dbbc3 (sets the 1GHz filters and the LO freqs)
Modules & Recorders
recorder2
slot 1: MPIH%028/48000
slot 2: MPIH%029/48000
recorder3
slot 1: MPIH%034/48000
slot 2: EHT%0036/48000
module setup (do on both recorders)
group=new:12 input_stream=add:stream1:vdif:8224:50:42:eth3:::1 input_stream=add:stream2:vdif:8224:50:42:eth5:::2 input_stream=commit group=open:12
Line injection test (2024 Nov 11th)
230 GHz signal chain
Line freq: 5754 MHz (corresponds to 215.256 GHz sky)
connected to boards A and B (corresponding to IF2 and IF4)
Line is expected to appear at 256 MHz in the filtered band. Difference in Pol. power comes from mislegnment of tone-injection horn.
86 GHz signal chain
Line freq 6744 MHz (corresponds to 86.256 GHz sky)
connected to boards C and D (corresponding to IF1 and IF3)
Line is expected to appear at 256 MHz in the filtered band. Difference in Pol. power comes from mislegnment of tone-injection horn.
Action
- Repeat phase test and tone injection if possible before observation
