Prepare the shell on lofarx with a running ssh-agent:
- ssh-agent /bin/tcsh -l
- ssh-add
Boot up the station:
- swlevel 2
- RSPDriver and TBBDriver need to be running
- tail -f /log/RSPDriver.log
- wait till no more lines: "port ??? has not yet completed sync or had errors, trying to continue..." show up for several seconds
- If anything strange appears, write it down in the observing logbook and tell the station team: lofar-ops@mpifr-bonn.mpg.de
- swlevel 3
- In addition to RSPDriver and TBBDriver also BeamServer needs to be running
- beamctl --antennaset=HBA_JOINED --rcus=0:191 --rcumode=5 --beamlets=0:243 --subbands=100:343 --anadir=0,1.5708,J2000 --digdir=0,1.5708,J2000&
- This should reach "All pointings sent and accepted" pretty fast.
- hit <enter> to get a clean commandline
- Wait a few seconds for all tiles to start up
- rspctl --rcu
- all 192 RCUs should be "ON" and in "mode:5"
- if some are "OFF", wait a few seconds and try again
- if some don't become "ON" then go bach to swlevel 1 and try again
- rspctl --stati --int=3
- check if the spectrum of all antennas look O.K.
- killpointing
- hit <enter> to get the confirmation that beamctl terminated
Comments:
- If at any time RSPDriver, TBBDriver, or BeamServer crash ("swlevel" show them as "DOWN") you need to go back to swlevel 1 and boot the station up again. (And note the fact in the logbook.)
