Table of contents
You are currently comparing two old versions - only when you are comparing against the latest version can you revert. Return to version archive.
Combined revision comparison
...
Hardware status and connections
- Check that the correct recorder/flexbuff is connected to the DBBC/Fila10G.
- IF cabeling corresponds to procedure file.
FS and backend
- Start the Field System.
- Check times with FMSET.
- Check the correct firmware is loaded to the DBBC and Fila10G. (dbbc=version, fila10g=version)
- Check the correct clock and input settings are set on the Fila10G (fila10g=sysstat). Might needs the loading the setup procedure before (e.g. proc=c182aef, setup01, ... wait and check)
- After loading the setup procedure:
- Check input level on IF
- Check counts on PFB channels.
- Check system temperatures with caltsys (if possible)
- Do a short test recording and run the checkdata.py script to look for proper bit statisitics and channel bandpass (see here as well)
Version from 11:04, 22 Mar 2019
...
Version as of 11:39, 22 Mar 2019
...
Hardware status and connections
- Check that the correct recorder/flexbuff is connected to the DBBC/Fila10G.
- IF cabeling corresponds to procedure file.
FS and backend
- Start the Field System.
- Check times with FMSET.
- Check the correct firmware is loaded to the DBBC and Fila10G. (dbbc=version, fila10g=version)
- Check the correct clock and input settings are set on the Fila10G (fila10g=sysstat). Might needs the loading the setup procedure before (e.g. proc=c182aef, setup01, ... wait and check)
- After loading the setup procedure:
- Check input level on IF
- Check counts on PFB channels.
- Check system temperatures with caltsys (if possible)
- Do a short test recording and run the checkdata.py script to look for proper bit statisitics and channel bandpass (see here as well)
