Table of contents
Combined revision comparison
...
- NOTE: System setup should be done a few hours ahead of the session to allow calibration to settle
- Turn on main power switch (backside)
- Power on the electronics ("EL switch" on the backside)
- Wait at least one second before you proceed to the next step
- Power in the PC ("PC switch" on the backside)
...
Version from 15:39, 2 Oct 2019
...
- NOTE: System setup should be done a few hours ahead of the session to allow calibration to settle
- Turn on main power switch (backside)
- Power on the electronics ("EL switch" on the backside)
- Wait at least one second before you proceed to the next step
- Power in the PC ("PC switch" on the backside)
Frontside LEDs should look like this (XXX)
...
Current version
...