The latest FILA10G firmware was obtained directly from the HatLab website (http://www.hat-lab.com).
After consulting with Gino Tuccari it has turned out that the FILA10G in PV has a model FX100
chip on the board and thus the fila10g_v2_0.bit needs to be used (FX60 boards would require fila10g_v2_1.bit).

The fila10g_v2_0.bit was installed under c:\DBBC_CONF\FilesDBBC

The configuration file c:\DBBC_CONF\dbbc_poly_config_file_14.txt was changed accordingly.




Here some additional unseful information by Gino concerning the capabilities of the different

FILA10G v1.0: the original version with one 10G port only, compiled for
FX100

FILA10G v1.1: the original version with one 10G port only, compiled for FX60

FILA10G v2.0: improve the 4 Gbps, 5B and VDIF-ST,  two 10G ports with
same data, FX100

FILA10G v2.1: improve the 4 Gbps,  5B and VDIF-ST, two 10G ports with
same data, FX60

FILA10G v3.0: 5B and VDIF-ST, two 10G ports with independent data, FX100
(under testing in these days)

FILA10G v3.1: 5B and VDIF-ST, two 10G porst with independent data, FX60

still to come, but under 'construction'

FILA10G v4.0: 5B and VDIF-ST and MT (corner turning), two 10G ports with
independent data, FX100

FILA10G v4.1: 5B and VDIF-ST and MT (corner turning), two 10G ports with
independent data, FX60