=== Disabling calibration loop

===Checking synthesizer lock state of board A
[OK] Locked

===Checking synthesizer lock state of board B
[OK] Locked

===Checking synthesizer lock state of board C
[OK] Locked

===Checking synthesizer lock state of board D
[OK] Locked

===Checking frequency of synthesizer 1
[OK] Freq=9048 MHz

===Checking frequency of synthesizer 2
[OK] Freq=9048 MHz

=== Checking IF power level on core board A
[OK] count = 31762

=== Checking IF power level on core board B
[OK] count = 31705

=== Checking IF power level on core board C
[OK] count = 32177

=== Checking IF power level on core board D
[OK] count = 31835

=== Checking sampler phases
[OK] OK

 ===Checking sampler gains for board A
[OK] sampler powers = [74286170, 73962529, 74702119, 73685714]

 ===Checking sampler gains for board B
[OK] sampler powers = [80580887, 80503572, 84124775, 80443246]

 ===Checking sampler gains for board C
[WARN] Large differences (>5%) in sampler powers for board=C. [88677110, 82110938, 80601730, 82391852] 6.269611%
[RESOLUTION] Restart the DBBC3 control software (no reload of firmware, re-initialize)
If the problem persists retry restart up to 5 times.
Possibly do a gain calibration (cal_delay=boardNum). Consult the documentation

 ===Checking sampler gains for board D
[OK] sampler powers = [70857237, 72958514, 71649135, 71454116]

===Checking sampler offsets for board A
[OK] Asymmetry = 0.017165%

===Checking sampler offsets for board B
[OK] Asymmetry = 0.026079%

===Checking sampler offsets for board C
[OK] Asymmetry = 0.040338%

===Checking sampler offsets for board D
[OK] Asymmetry = 0.032243%
Do you want to set the tap filters now? [y/n]y
=== Loading tap filters for board A
=== Loading tap filters for board B
=== Loading tap filters for board C
=== Loading tap filters for board D
=== Setting up calibration loop
=== Enabling calibration loop
=== Waiting for 1 minute to allow adjusting the power levels
=== Now re-checking the bit statistics (should be proper 2-bit)

===Checking sampler offsets for board A
[OK] Asymmetry = 0.001044%

===Checking sampler offsets for board B
[OK] Asymmetry = 0.013324%

===Checking sampler offsets for board C
[OK] Asymmetry = 0.021722%

===Checking sampler offsets for board D
[OK] Asymmetry = 0.021092%
=== Setting up calibration loop
=== Enabling calibration loop
=== Done